Introduction of nitrile glove production line

Six, impregnated CaCO3 coagulant.
① Coagulant CaCL2 content control at 10 ± 3%, CaCO3 content control at 15 ± 5% (precipitation 2 hours to determine), each shift after the test CaCO3 content.
②The temperature of the coagulant tank is required to be 45±15℃.
③ coagulant drying requirements: 95±5℃.
④ The coagulant drying temperature should be adjusted according to seasonal changes, should be dried at the lowest possible temperature to complete, in July-September when it is difficult to reduce the mold temperature should open the cooling window to reduce the mold temperature.
Impregnating latex.
① impregnation tank conditions should meet the total solids content of 30 ± 1%
②Gel temperature: 30±10℃
③ Every 50-60 minutes with a scraper to clean up the surface of the latex, latex surface shall not have rubber, garbage, etc.
④The impregnation tank should be re-filtered with 80 mesh screen every 20-30 days to turn over the slurry once, such as encountering sudden glue particles or snow defects should be turned over in advance according to the situation. The bottom corner material after turning pulp should be placed separately and filtered before use, and those that cannot be used should be sent to the designated place for disposal.
⑤ The screen should be cleaned once every 1 hour and recorded (the replacement cleaning screen should be cleaned by turning off the circulation pump for 3-5 minutes and then taking out the screen to prevent the impurities of rubber particles from flowing into the impregnation tank in the state of latex flow) The scraping board should not be close to the inner wall of the rubber tank to prevent the rubber skin on the wall of the tank from scraping off and sticking to the gloves.
⑥The rubber liquid surface should be kept flowing, the rubber pump should run continuously, if the rubber material finds pulp particles, the rubber pump should be closed and opened again after the pulp is turned over or normal.
(7) The scraper to clean the pulp skin garbage on the glue liquid surface should be cleaned with drinking water in the special cleaning barrel to keep it clean, and the cleaned water should be sent to the designated place for disposal.